User guide

52
NTC-40 –HSPA+ M2M WiFi Router with Voice
YML40V
www.netcommwireless .com
NTC-40 Series – HSPA+ M2M WiFi Router
Diagnostics
The Diagnostics page is used to configure the SMS Diagnostics and Command execution configuration. This enables you to
change the configuration or check on the status of the router via SMS commands.
Figure 49 - SMS Diagnostics Settings
The following section details the configuration items available.
Enable Authentication
Enable or disable checking the sender’s phone number against the allowed sender “White List” for incoming Diagnostics/Command
Execution SMS messages.
If authentication is enabled, the router will check if the sender’s number exists in the “White List”. If it exists, the router then checks
the password in the incoming message against the password in the “White List” for the corresponding sending number. If they
match, the Diagnostics/Command is executed.
If the number does not exist in “White List” or the password does not match, the router does not execute the incoming
Diagnostics/Command Execution SMS message.
This is enabled by default.
It is highly recommended to enable security when utilising the Diagnostics/Command Execution feature.
Send Ack. SMS for Set Command
Enable or disable sending an acknowledge message after execution of a “Set” command. If disabled the router does not send any
acknowledgement after execution of a “Set” command.
This can be useful to determine if a command was received and executed by the router. This is disabled by default.