User guide

YML40V
www.netcomm-commercial.com.au
NTC-40 –HSPA+ M2M WiFi Router with Voice
39
NTC-40 Series – HSPA+ M2M WiFi Router
Wireless LAN
Configuration
The configuration page is used to define the basic wireless settings for the NTC-40 such as the SSID and Wireless Security in use.
Figure 34 - Wireless Configuration - Basic Settings
OPTION
DEFINITION
Radio On/Off
WiFi is turned on by default. Changing this option to OFF will turn OFF the wireless functionality on the NTC-40 and you will not be
able to connect wirelessly.
Country
Select the country you are operating the NTC-40 in.
Network Mode
There are 6 possible network modes to use depending on the capability of your devices’ wireless network cards. Each mode
represents one or more wireless network protocols. Each wireless device will be capable of receiving some but possibly not all of
wireless broadcast protocol types. They are:
 802.11b/g/n mixed mode.
 802.11b only.
 802.11g only.
 802.11n only.
 802.11b/g/n mixed mode.
Frequency (Channel)
Select the wireless channel that the wireless signal will broadcast on.
SSID
The SSID (Service Set IDentifier or Network Name) in use for the wireless network.
Network Authentication
The wireless security settings. See below for in depth analysis.
WPA Pre-Shared Key
The wireless security key or wireless password.
WPA Group Rekey Interval
The time in seconds before a new key is generated.
WPA Encryption
The type of WPA encryption. Options include AES, TKIP or TKIP + AES.
MAC Address
The MAC address of the wireless network card.
WDS Mode
The Status of the WDS (Wireless Distribution System) Mode
Table 22 - Wireless Configuration - Basic Configuration Items
Click ‘Apply’ to save any changes to the settings.