User guide

YML40V
www.netcomm-commercial.com.au
NTC-40 –HSPA+ M2M WiFi Router with Voice
19
NTC-40 Series – HSPA+ M2M WiFi Router
Internet Settings
This section describes how to set up the router to initiate a mobile broadband connection. There are 2 different ways to set up a
mobile broadband connection via PPP:

Initiating the PPP Connection directly from the router (most common).

Initiating the PPP Connection from a different PPP client (i.e. laptop or router) with the router running in transparent
PPPoE mode.
Mobile Broadband
Connection
Click on the “Internet Settings” menu followed by “Mobile Broadband“ and then the “Connection” menu item on the right.
Figure 12 - Connection Settings
To connect using a Connection profile
The router supports multiple APN profiles; these profiles allow you to configure the settings that the router will use to connect to the
3G network. By default, the “Profile 1” profile is selected. If the “Automatically configure my mobile broadband” option is selected
the router should automatically detect the applicable APN from the inserted SIM after a reboot.
You can also manually enter the connection details by performing the following steps:
1. Select the profile that you wish to configure
2. Enter a name for the connection (if needed) in the “Change Profile Name” field.
3. Select the appropriate connection type.
4. Enter the APN (and if required the username and password).
5. Select “Enable” for the Auto Connect option.
6. Select the Authentication Type.
7. Enter the Reconnect Delay (if needed - the default should be suitable in most cases).
8. Enter the number of Reconnection attempts the router should make.
9. Enter the network metric for the connection.
10. Select to enable or disable NAT Masquerading for the connection.
11. Click Save