User guide

YML40V
www.netcomm-commercial.com.au
NTC-40 –HSPA+ M2M WiFi Router with Voice
13
NTC-40 Series – HSPA+ M2M WiFi Router
Installation and Configuration of
the NTC-40
Connecting via an Ethernet cable
1. Connect the Ethernet cable provided to the port marked “Ethernet” on the side of the NTC-40.
2. Connect the other end of the yellow Ethernet cable to your computer.
3. Wait approximately 30 seconds for the connection to establish.
Connecting via wireless
1. Ensure WiFi is enabled on your device (computer/laptop/Smartphone).
2. Scan for wireless networks in your area and connect to the network name that matches the Wireless network name
configured on the NTC-40.
3. When prompted for your wireless security settings, enter the Wireless security key configured on the NTC-40.
4. Wait approximately 30 seconds for the connection to establish.
Configuring the NTC-40
1. After connecting via Ethernet cable or wirelessly, open your Web browser, and enter http://192.168.1.1 into the address
bar and press enter.
2. Follow the steps on the next pages to set up your NTC-40.