Digital satellite antenna with control panel MobilSat+ User’s Manual Models: MSP-S / MSP-C
MobilSat + User’s manual SUMMARY 1. Introduction..........................................................................................................................................2 1.1. Usage..............................................................................................................................................2 1.2. General notes .................................................................................................................................3 1.3.
MobilSat + User’s manual For correct operations, please take care to have a “free view toward South”, because the most of TV satellites that covers central Europe are positioned in South direction. If there’s an obstacle (building, mountain, tree, etc) between the caravan and the South line, it will be not possible for the system to receive correctly to the satellite signal. 1.2.
MobilSat + User’s manual 2. Base functions In this chapter are described all the “base” operations, needed to operate the system most of the times. Normally, to power on the system and to receive a correct satellite signal, the only thing to do is to press the ON/OFF key. 2.1. Power on and automatic satellite search 1. Press ON/OFF key; the antenna moves automatically to the point where was positioned the last time when the system was witched off. At this point there are two possibilities: A.
MobilSat + User’s manual During the closing procedure, the display will show the following indications: ANTENNA CLOSING The beeper issues a “high” tone for the entire procedure and will stop only when the antenna will be completely closed. At the end of the procedure the display will be switched off. 3. Advanced functions 3.1.
MobilSat + User’s manual If the search procedure will find a correct signal for the new satellite, the beeper issues a 3 seconds tone and the display will show: SAT FOUND < Sat2 name > Now the system is ready to be used. No other operation must be performed. Enjoy your TV programs. Within 5 minutes the system will automatically switch to stand-by status. If the procedure will NOT find a good signal, the system will go back to the Sat Search Menu. 3.2.
MobilSat + User’s manual For positive values it is necessary to rotate the LNB CLOCKWISE, using the “zero” indication on the LNB support as reference. For negative values the arm must be rotated COUNTERCLOCKWISE. As displayed in the following pictures, to perform this operation unscrew with an 3mm Allen wrench the two screws that fix LNB and rotate the LNB until the desired value is displayed in the hollow of the upper plate.
MobilSat + User’s manual 4.
MobilSat + User’s manual 5. Failures or errors If during normal operations the system detects an error, the beeper issues a special tone (5 times) and shows on the display the anomaly found. In the following table are displayed the most common failures/errors and the related solutions, if applicable.
MobilSat + User’s manual 6.
MobilSat + User’s manual _________________________________________________________________________________ _________________________________________________________________________________ _________________________________________________________________________________ _________________________________________________________________________________ _________________________________________________________________________________ __________________________________________________________________________
MobilSat + User’s manual 7. References Mobiltech s.a.s. Via Brughetti, 9/E 20030 Bovisio Masciago (MI) Tel: (+39) 0362 – 544.928 Fax: (+39) 0362 – 576.478 Internet: www.mobiltech.it Mailto: info@mobiltech.
