Technical data

MobilSat
+
Mounting instructions
Page 6 of 12
For a complete rotation of the antenna during the normal operation the roof of the vehicle must be
free of obstacles, as displayed in the following figure.
NOTE
For difficult installations caused by space problems, it must be underlined that the plate and the
LNB arm turns at a minimum height of 25 centimeters. Any obstacles present in the rotation area
but lower than 25 cm will not influence normal antenna operations.
6.3. Mounting of the assembly plate
After having decided the mounting location and after having verified antenna positioning during
stand-by time related to driving direction, mark on the roof the corner points of the mounting plate.
ATTENTION
It’s absolutely needed to mark the roof of the vehicle with a line, in order to exclude the possibility
to mount the assembly plate in a wrong direction. MobilSat
+
antenna can be mounted in only one
direction; LNB must be oriented towards the rear of the vehicle. All other positions will not be
considered as correct and will cause immediate guarantee expiration.
Remove the system from the assembly plate unscrewing the four nuts. The assembly plate must
be glued to the roof using a commercially available sealing compound. For the cleaning of the roof
and the assembly plate use a special cleaning agent recommended by the manufacturer of the
sealing compound (e.g. SikaFlex, Teroson 1K-Pur). After the sealing compound has been dried,
apply the sealing compound to the bottom of the plate and strongly apply the plate to the roof of the
vehicle. If the roof of the caravan does not have the needed consistency, fix the plate with the
tapping screws, in order to obtain a stable and safe assembly. The manufacturer can not be
indicated as responsible for damages caused by an incorrect mounting.