Technical data

MobilSat
+
Mounting instructions
Page 4 of 12
Modifications to the electrical installations in the vehicle should only be carried out by a specialist in
vehicle electrics. Do not make any unauthorized changes to the turntable.
2.4. Adhesive sealant
The turntable is attached to the roof of the vehicle by adhesive and is secured by additional fixing
screws. Note that the curing of the adhesive sealant is temperature-dependent. It reaches its full
strength only after approximately five days.
2.5. Road Traffic Licensing Regulations
The applicable regulations must be observed in respect of fixed installation of the turntable on a
vehicle which is driven on public highways.
In particular, §§ 19/2; 30 C; 32 (2) and the EC directive 74/483 EEC are applicable. Briefly, they
state that no endorsement of the vehicle documentation is required unless the antenna unit causes
the height of the laden vehicle to exceed 2mt, or the antenna unit projects beyond the outer lateral
outline of the vehicle. The maximum permissible height of 4mt (vehicle and antenna unit) may not
be exceeded.
3. Certifications
MobilSat
+
complies with the following regulations:
Electromagnetic compatibility: EN55022, EN55024
Safety: EN12100-1, EN12100-2, EN294, EN349
IP graduation: EN60529
Vibrations: 95/56/CEE
4. Package contents
The received package contains the following items:
- Control Unit
- External unit with antenna dish
- Command unit
- Mounting plate
- Power cable
- Cable set (4mt) for external unit
- Cable (5mt) for command unit
- Coaxial cable (1,5m) for satellite receiver
- Mounting instructions
- User’s manual
- C.I. satellite receiver (with kit MSP-C)