User Guide

ManualsBrandsMobilogix ManualsAsset TrackerMobilogix VZGAT-CM1-001 GLOBAL ASSET TRACKER

GAT (GLOBAL ASSET TRACKER)

VZGAT-CM1-001

USER GUIDE

V2020-07-08

Summary of content (9 pages)

PAGE 1
GAT (GLOBAL ASSET TRACKER) VZGAT-CM1-001 USER GUIDE V2020-07-08
PAGE 2
GAT PAGE | 2 OF 9 1 CONTENTS 2 Introduction ....................................................................................................................................................................................... 3 3 Quick Start ......................................................................................................................................................................................... 3 4 3.1 Interfaces ......................................................
PAGE 3
GAT PAGE | 3 OF 9 2 INTRODUCTION The GAT is a multi-purpose LTE CAT-M1 / NB1 and 2G (GSM/GPRS/EDGE), IP67 rated mobile asset tracking and monitoring device with various onboard sensors including temperature, pressure, humidity, light, a 3-axis IMU/Gyroscope, and GNSS/GPS. It also boasts WIFI LAAS and BLE (Bluetooth Low-Energy) connectivity.
PAGE 4
GAT PAGE | 4 OF 9 3.2 LED STATUS INDICATORS 3.2.1 • • 3.2.2 • • • 4 The color of the power LED is set according to the percentage battery level remaining as follows: o Green: Battery level remaining is greater than or equal to 40%. o Yellow: Battery level remaining is less than 40% and greater than or equal to 20%. o Red: Battery level remaining is less than 20%. The power LED stays on when the radio is on and blinks when the radio is off.
PAGE 5
GAT PAGE | 5 OF 9 5.2 SETUP (SHIP) MODE Description: 1. 2. 3. How the device leaves the factory and shipped to a warehouse or distribution center Lowest power state Mode for long-term storage Mode Entry Actions: 1. 2. 3. 4. Disable all sensors and alarms (no data collection) Turn off all modules: cellular, Wi-Fi, GNSS.
PAGE 6
GAT PAGE | 6 OF 9 6 HARDWARE 6.1 MAIN PROCESSING COMPONENTS The GAT comprises 2 primary communication and processing modules, the Quectel BG96G, and the Silicon Labs BlueGecko EFR32BG12. The BG96 and EFR32BG12 operate cooperatively and communicate via a dedicated UART serial interface, using a proprietary, message packet-based protocol (Ref. 7, GAT Software Radio to Sensor Message Protocol). 6.1.
PAGE 7
GAT PAGE | 7 OF 9 6.5 RADIOS Cellular Module: Bluetooth Module: Antenna: Quectel® BG96 (Qualcomm® MDM9206) Silabs® EFR32BG12 Embedded Cellular/GPS/Bluetooth (Rx)/WiFi (Rx) Radio Frequencies: LTE-FDD B1 LTE-FDD B2 LTE-FDD B3 LTE-FDD B4 LTE-FDD B5 LTE-FDD B8 LTE-FDD B12 LTE-FDD B13 LTE-FDD B18 LTE-FDD B19 LTE-FDD B20 LTE-FDD B26 LTE-FDD B28 LTE-TDD B39 850 (B5) 900 (B8) 1800 (B3) 1900 (B2) GPS Bluetooth WiFi 1920 1850 1710 1710 824 880 699 777 815 830 832 814 703 2570 824.2 880.2 1710.2 1850.
PAGE 8
GAT PAGE | 8 OF 9 7 CONTACTS • • 8 8.1 support@mobilogix.com https://mobilogix.com/contact/ DISCLAIMERS FCC INTERFERENCE STATEMENT (PART 15.105 (B)) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 9
GAT PAGE | 9 OF 9 8.4 ISED RSS-GEN NOTICE This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.