User guide

FCC Statement
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced technician for help.
The highest SAR value for the computer when next to the
body, as described in this user guide, is 1.17 W/kg. No
1)
2)
3)
4)
separation from the body is required when the wireless
computer is in operation, as the SAR measurements were
taken with the unit “touching” the surface of the body.
This device was tested for SAR compliance in the lap held
configuration. If the device is purchased with the WWAN
option, a whip antenna is utilized for WWAN coverage. When
operating in WWAN mode, the whip antenna should be pulled
out and up to the vertical position. In order to comply with
FCC RF exposure requirements, and to align with the SAR test
configuration, users must maintain a separation distance of
1.5 cm between the antenna and all persons, and maintain the
antenna in the vertical position during WWAN operation.
This Class [B] digital apparatus complies with Canadian ICES-
003. Cet appareil numérique de la class [B] est conformé à la
norme NMB-003 du Canada.
The IEEE 802.11a device for the band 5150-5250 MHz is only
for indoor usage, to reduce the potential for harmful interfer-
ence to co-channel mobile satellite systems.
Caution: Any changes or modifications not expressly approved
by OQO for compliance will void the user’s authority to operate
the equipment.