User's Manual

ManualsBrandsMobiletron Electronics ManualsAutomotiveTire Pressure Monitoring System

Installation and Operating Instructions

For

Tire Pressure Monitoring System

Model No.

：TX008

Contents

1. System Introduction

2. Safety Features

3. Applicable Vehicles

4. Installation Tools Required

5. Mounting the Tire with Transmitter on Wheel Valve

6. Transmitter Technical Specifications

Summary of content (5 pages)

PAGE 1
Installation and Operating Instructions For Tire Pressure Monitoring System Model No. ：TX008 Contents 1. System Introduction 2. Safety Features 3. Applicable Vehicles 4. Installation Tools Required 5. Mounting the Tire with Transmitter on Wheel Valve 6.
PAGE 2
1. System Introduction 1.1 TX008 is a wireless tire pressure monitoring system with sensors and transmitters mounted in each tire. Highly accurate sensors collect tire pressure and temperature data which is transmitted to a Digital Display Receiver. 1.2 The System monitors the tire data with a LCD display which informs the driver of the condition of the tires while driving.
PAGE 3
5. Mounting the Tire with Transmitter on Wheel Valve Please follow the installation steps below. Once the installation completed, please rebalance the tire again. ※ The fixed torque for spinning the transmitter suggested to set at 9~10 Kgf.cm (1) Start to install transmitter onto the tire (2) Spin the transmitter onto the inner tire valve Note：The fixed torque suggested to be set at 9~10 Kgf.cm. Transmitter for better tire rebalancing (3) One-wheel installation is completed.
PAGE 4
6. Transmitter Technical Specifications 6.1 Operation Condition Description Pressure Range Rated Pressure Value 0 ~ 180 240 -40 ~ +85 -40 ~ +185 0 ~ 100 Operating Temperature Operating Humidity Accuracy +/- 5 +/- 3 +/- 5 - 6.2 Radio Frequency Transmitter Description Value Units Central Frequency 433.92 MHz Description Value Units Weight 21.5 Gram 6.3 General Specification 6.4 Power Description Power Source Battery Life Value Units 3.
PAGE 5
1. The device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 2.FCC RF Radiation Exposure Statement: The equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.