User's Guide

Always have your Base Station and Mobile Device nearby when testing your
system. It is possible that the alarm may go to a live operator.
You can use the TEST button on your Base Station and Mobile Device to
conduct a test without speaking to an Emergency Response Operator by
following these steps:
Press and hold the TEST button on Base Station until it illuminates green.
Press and hold the TEST Button on Mobile Device (the button on the side with
the letter “T”).
You will hear an announcement over the Base Station and Mobile Device that
will instruct you to press the Emergency Button or Pendant.
Press the Neck Pendant or Wrist Button.
The Base Station and Mobile Device will announce “test call sent to
Emergency Response Center.”
If your test was successful, you will hear “thank you for testing your device”
from the Base Station and Mobile Device.
If your test was not successful, the Base Station will announce “user auto-test
failed.”
Please contact Technical Support.
If by chance the operator speaks to you, please state clearly that “THIS IS A
TEST.” If you do not explain to the operator that you are okay and that you
are testing, EMS will be contacted.