User's Guide

The yellow light on the front of the cradle charger will illuminate. If it does not, make
sure you have placed the Mobile Device correctly in the charger.
- ON, blinking periodically – indicates the charger is in a “fast charging” state, to charge the
MD 4.0 device more quickly.
- ON, no blink – once the device battery level is almost fully charged, the charger switches
from the “fast charging” state to a slower charging state, which is indicated by the
Amber LED being a solid light.
O - FF – when the device sitting in the charger is considered to be fully charged, the
cradle stops supplying current to the device and the Amber LED is turned OFF.
The Mobile Device will turn on within 10 seconds and then it will take about 60
seconds for the Mobile Device to register with the network.
The red battery light will illuminate, indicating that the device still needs charging.
When the device is fully charged, the red light will turn off. It will take up to 3 hours
for the device to be fully charged.
Press the ON/OFF button on the side of the Mobile Device and hold
Simply place the Mobile Device in the cradle charger, assuming the
cradle charger is plugged in.
All the lights will turn on and the green light will start blinking. This indicates
the Mobile Device was successfully turned on and you will hear “system ready.”
Press the ON/OFF button and hold until the
red battery light illuminates. It will take anywhere
from 10 seconds up to 2 minutes for the Mobile
Device to power down. All the lights will turn off.
This indicates your Mobile Device was success-
fully turned off.