Users Manual Part 2

Vehicle Monitoring and Locating System Mobile Video Computing Solutions LLC
Tow Truck Installation Procedures
28 September 21, 2021
Installation Steps
1) Hold the doghouse next to the winch bracket and look for any available bolts which
can be loosened and used to secure the doghouse. If none are found, determine if
drilled holes or some tack welds could be used to secure the doghouse to the top of
the winch bracket. Secure the doghouse.
2) Mount the camera bracket to the Camera Mount Bracket with sheet metal screws and
place the bracket inside the doghouse.
3) Route the camera cable to the underside of the bed and connect to either the Coiled
Ethernet Cable (single bed camera) or Ethernet Switch Module (multiple bed
cameras) with a watertight Ethernet connector.
4) If the MDVR isn’t powered up yet, don’t securely tighten the camera aiming screws
until the camera aiming step later.
This section intentionally blank