User`s guide

the connection on the PC.
To disconnect, tap on the active connection icon in the Windows tray, select the Disconnect option,
wait a few seconds while the connection is shutting down and disable the modem mode on the Treo.
2.2.1. Creating a New Connection
The connection setup procedure must be performed after a successful installation of the USB Modem
driver.
1. Consult your wireless provider on the important parameters that are necessary to setup the
connection. These include the dial number, user name and password. For GPRS or EDGE
connections the access point name (APN) is also required.
2. Start the Create a new Connection wizard. To do this, press the Windows Start button, select
Connect To, choose Show all connections and look for the wizard in the Network Tasks area
in left of the panel. Alternatively, go into Windows Control Panel and choose the
Network Connections item.
3. The Welcome to the New Connection Wizard screen will be displayed. Press the Next button
to proceed.
4. The Network Connection Type screen will be displayed. Select the Connect to the Internet
and press the Next button.
5. The Getting Ready dialog will appear. Select the Set up my connection manually option and
press the Next button.
6. The Internet Connection dialog will appear. Choose the Connect using a dial-up modem
and press the Next button to proceed.
7. The Connection Name screen will be displayed. Type in the name of the connection. For
example, Internet via Treo USB Modem looks good. Press the Next button.
8. The Phone Number to Dial screen will be displayed. Type in the dial number provided by the
wireless operator and press the Next button. Usually the number is #777 for CDMA networks
and *99***1# (or just *99#) for GSM networks.
9. The Internet Account Information screen will be displayed. Enter the user name and
password as provided by the wireless operator, disable the Make this the default Internet
connection checkbox and press the Next button.
10.The Completing the New Connection Wizard screen will be displayed. Enable the
Add a shortcut to this connection to my desktop for easy connection access and press the
Finish button.
11.This step is necessary for GPRS or EDGE connections only. Proceed directly to step 12 for
CDMA data connection!
1. Connect your Treo to the PC using a USB cable and enable the modem mode in the
USB Modem application. Press the Windows Start button, select Control Panel,
launch the Phone and Modem Options panel, select the Treo 650 USB Modem entry
(or named according to your actual device) in the Modems tab and press the Properties
button.
Page 4 of 12