Use and Care Manual

CHARGING INSTRUCTIONS

THE RECHARGEABLE WORK LIGHT MUST BE FULLY CHARGED BEFORE

BEING USED FOR THE FIRST TIME. IT IS RECOMMENDED THAT THE

BATTERY BE RE-CHARGED EVERY 3 MONTHS TO ENSURE MAXIMUM

PERFORMANCE IN AN EMERGENCY.

This will ensure that the battery gives its best performance now and on

future re-charging cycles. The AC charging adapter is for re-charging the

battery only. Always ensure that the light switch is in the OFF position while

charging.

Note: Recharge unit when only one green LED light from the battery

status indicator comes ON.

USING THE AC CHARGING ADAPTER:

1. Plug the AC charger into the charging port on the base of the unit next

to the charging LED indicator.

2. Plug the AC adapter into a 120V outlet and switch ON the outlet (if

applicable).

3. The battery will be fully charged after approximately 5-6 hours,

4. Disconnect the AC charger from the light and remove the adapter from

the wall outlet.

NOTE: TO PREVENT OVERHEATING DO NOT CHARGE FOR MORE

THAN 8 HOURS.

CHARGER

INPUT

ON/OFF

POWER SWITCH