Instruction manual

ACU-1000 Operations Manual
Interoperability Now 2-49
2.14 Configuration Programming Via the WAIS Controller
The WAIS controller may be used to configure some or all of each module’s features except for
the HSP-2A and CPM-4 as they have no configurable features. If a system contains multiple
WAIS Controllers, this should be done with caution as each of the other WAIS controller sites
has no indication of change and also has the ability to initiate change. It is strongly advised
that change control be password limited to properly trained personnel. See Figure 2-16 for a
flow chart of the process. The configurable items for each module are shown in the subsequent
sections.
Select DSP-2
Parameters
See Section
2.18.2 for
explanation.
(See Table 2-22)
HSP-2A Module
Program via
WAIS Controller
DSP-2 Module
Program via
WAIS
Controller
PSTN-1
Program via
WAIS
Controller
Click Module
Icon Button
Start WAIS
Controller
Program
Connect
ACU-1000 &
WAIS Controller
PC to LAN/WAN
LP-1 Module
Program via
WAIS
Controller
Select PSTN-1
Parameters
See Section
2.18.3 for
explanation.
(See Table 2-22)
Test Channel
Good
Not Good
Select LP-1
Parameters
See Section
2.18.4 for
explanation.
(See Table 2-22)
Finished
Click Set
There are No
WAIS Controller
Programmable
Items
Select Local
View of Selected
ACU-1000
Figure 2-16 Programming via WAIS Controller Program