Instruction manual

ACU-1000 Operations Manual
2-48 Interoperability Now
2.13 Configuration Programming Via the ACU Controller
The ACU-1000 modules may be individually programmed via the ACU Controller, the WAIS
Controller, or using the HSP-2A Keypad. This ACU Controller is the recommended method
and this section covers its use. See Figure 2-15 Programming via ACU Controller
Program, for a flowchart of the process. Section 2.17 provides further detail on each of the
configurable items.
Select DSP-2
Parameters
See Section
2.18.2 for
explanation.
(See Table 2-22)
HSP-2A
Module
Program via
ACU Controller
DSP-2 or RDI-1
Module
Program via
ACU Controller
Click APPLY
Click OK
Click on center
of each HSP-
2A Module Icon
Start ACU
Controller
Program
Connect PC to
ACU-1000
PSTN-1
Program via
ACU Controller
Click on center of
each Module Icon
Start ACU
Controller
Program
Connect PC to
ACU-1000
LP-1 Module
Program via
ACU Controller
Select PSTN-1
Parameters
See Section
2.18.3 for
explanation.
(See Table 2-22)
Load Template
Customize
Click APPLY
Test Channel
Click OK
Good
Not Good
Yes
No
Select LP-1
Parameters
See Section
2.18.4 for
explanation.
(See Table 2-22)
File Save
New Configuration
Click OK
Click Save
Select Default
Parameters
for Items Shown
Finished
Reload New
Configuration
File Save
New
Configuration
Finished
Reload New
Configuration
Figure 2-15 Programming via ACU Controller Program