Instruction manual

ACU-1000 Operations Manual
2-42 Interoperability Now
2.12.3 CPM-4 Jumper Settings
The CPM-4 has a single jumper; it may be used to reset the module back to factory default
settings if this becomes necessary. The following settings will be reset back to factory default.
• All module settings
• All module names
• Chassis configuration
• Serial baud rate and serial port data bits, stop bit, and parity
• All IP related settings such as IP address, subnet mask, gateway
• All VoIP settings
Table 2-12 Restore Factory Default – J16
Restore Factory Defaults J16 1-2
Do not restore Factory Defaults J16 2-3 *
* denotes factory default setting
...
J16
3 2 1
CPM-4
Ethernet
Connector
NORM
RESTORE
Figure 2-11 CPM-4 Module Showing Jumper Location