Instruction manual

ACU-1000 Operations Manual
8-4
Radio to Radio
Operation, 3-17
Regain Control
HSP-2 Operational Command Items, 3-8
Regain Control from Console Program
HSP-2, 3-10
Related Equipment, 1-12
Removal and Replacement of Modules, 3-5
Report Connections
HSP-2, 3-9
HSP-2 Operational Command Items, 3-8
Reshipment of Equipment, 2-1
Ring LED (PSTN-2, LP-2), 3-7
SCM-2
Configuration Programming via Browser, 2-81
Serial Remote Connections- P15, 2-16
Serial Remote Connector, 2-16
Set ACU-1000 Extension Security Levels, 3-15
Set RX Level Procedure, 4-10
Set TX Level Procedure, 4-11
Signal LED (RDI-1, DSP-1), 3-6
Simplex, 1-6
Speaker Switch (HSP-2), 3-5
Store Connection Table in Memory
HSP-2, 3-10
Store Connections
HSP-2 Operational Command Items, 3-8
Stored Connections, 2-86
STU-3
Alignment, 6-3
Basic System, 6-1
Cable Schematic, 6-5
Cross Connecting, 6-4
Equipment Required, 6-1
Installation, 6-2
Internal Wiring Diagram, 6-7
Required Applications, 6-1
STU-3 Option, 6-1
Stuck Channel, 4-1, 4-5
System Programming and Operating Items, 2-84
Console Override, 2-84
Delete Pin's, 2-85
Enter Programming Mode, 2-84
Exit Programming Mode, 2-84
Module Security Level Selection, 2-85
Pin's, 2-85
Program Pin's, 2-85
Reset Modules to Factory Settings, 2-84
Select a Module to Program, 2-84
System Programming Item, 2-83
System Reset, 3-11
HSP-2 Operational Command Items, 3-8
Interface Module Operational Commands, 3-11
System Reset Feature
HSP-2, 3-11
Interface Module Operational Commands, 3-13
Table of Contents, 3
Troubleshooting, 4-1
Trunked Channel Acquisition Delay, 4-2
Two Different PIN Security Modes, 3-14
TX Priority, 4-7
Unit Power-Up
O
peration, 3-5
Unpacking and Inspection, 2-1
Unwanted Connections, 4-13
VMR, 2-94
Volume Control (HSP-2), 3-6
VOX, 1-7, 2-93
WAIS, 1-2
Cross-Connection
Pictorial Overview, 1-5
WAIS Controller, 1-15, 2-49, 3-4