Instruction manual

ACU-1000 Operations Manual
8-1
8 Index
+12V and -12V Indicators (PSM-1), 3-5
2-wire device, 1-4
4-wire device, 1-4
AC and DC Indicators (PSM-1), 3-5
AC Line Voltage Selection, 2-6
AC Power Requirements, 2-6
ACU Controller, 3-2
ACU-1000
Card Cage, 1-10
Charge Switch, 2-9
CPM-4, 1-11
DSP-2 Module, 1-11
General, 1-9
HSP-2A, 1-10
LP-2 Module, 1-12
Power Supply Module, 1-10
PSTN-2 Module, 1-11
RDI-1 Module, 7-21
Specifications, 1-20
ACU-1000 Hardware Configuration Settings, 2-39
ACU-1000 Technical Information, 5-1
ACU-Controller, 1-12
ACU-T, 1-19
Attention Command
HSP-2, 3-9
HSP-2 Operational Command Items, 3-8
Interface Module Operational Commands, 3-11,
3-12
Audio Equalization, 4-12
Auto-Restore, 2-86
Basic Operation Scenarios
Operation, 3-17
Battery Power for the ACU-1000, 2-7
Baud Rate, 2-86
Break a Connection
HSP-2, 3-9
Interface Module Operational Commands, 3-12
Break the Current Connections
HSP-2 Operational Command Items, 3-8
Interface Module Operational Commands, 3-11
Browser, 2-53
Card Cage and Backplane
Technical Information, 5-1
Chassis Slots, Extensions, Connectors, and
Modules,
2-13
Common Problems/Solutions
Delays, 4-3
Conference Call
Operation, 3-20
Configuration, 2-53
Configuration Programming Items, 2-83
Connect LED (PSTN-2), 3-7
Control and Connector Locations, 2-5
Cooling, 2-3
COR, 1-6
COR LED (RDI-1, DSP-1), 3-6
CPM Module
Software Updates, 2-67
CPM Module
Configuration Programming via Browser, 2-53
Information Page, 2-66
CPM-2, 1-4
Baud Rate, 7-18
Expanded System Configuration, 7-19
Manufacturing Test SW1-8, 7-19
Remote Control Baud Rate, 7-18
Serial Sync Character, 7-18
SW1-5, 7-19
SW1-8-8, 7-19
SW2-1 through SW2-8, 7-19
Switch Settings, 7-17
CPM-2 Control Processor Module
Technical Information, 5-2
CPM-2 Hardware Configuration Settings, 7-17
CPM-4 Jumper Settings, 2-42
CPM-4 replaces CPM-2, 7-17
Cross-Connection, 1-4
Monitor, 1-9
Multiple, 1-9
CSAP, 1-1
Data / Command Modes
HSP-2, 3-10
Interface Module Operational Commands, 3-13
Data /Command Mode
Interface Module Operational Commands, 3-11
Data/Command Mode
HSP-2 Operational Command Items, 3-8
DC Input Connector, 2-14
DC Power Requirements, 2-7
Delete PIN Numbers from the Database, 3-16
Description of Programming Items, 2-90
Disconnect Another Extension
HSP-2, 3-9
HSP-2 Operational Command Items, 3-8
Dispatcher Priority, 4-8
DSP Module