Instruction manual

ACU-1000 Operations Manual
Interoperability Now 3-15
3.6.2.2.2 Exclusive Operation Mode
Access is granted only if the PIN security level is equal to the security level of the extension
the user is requesting to be connected. A PIN at security level 6 will allow the user to make a
connection with an extension set to level 6, but not to any extension with security levels from 1
to 5 or 7 to 9. Access to extensions set to security level 0 does not require PIN numbers.
3.6.2.3 How to Enable PIN Security
• Enter “SETUP MODE” * 9 9 .
• To enable Priority Mode PIN numbers enter * 2 9 1, and listen for the “READY” prompt.
To instead enable Exclusive Mode PIN numbers enter * 2 9 2.
• To disable PIN numbers (either mode) enter * 2 9 0, and listen for the “READY” prompt.
• To save the configuration enter * #, and listen for prompt “SAVING CONFIGURATION”,
followed by “CONFIGURATION HAS BEEN SAVED” after the ACU-1000 has completed
storing all system parameters.
3.6.2.4 How to Set ACU-1000 Extension Security Levels
• Enter “SETUP MODE” * 9 9.
• Select the extension to be programmed. For example, to program the module at extension
05 enter * 0 1 0 5, and listen for the “READY” prompt.
• Now enter the security level * 3 2 n, where n is the level from 0 to 9. The higher the
number the more secure. Listen for the “READY” prompt. For example: To set a security
level of five, enter the command * 3 2 5.
• Repeat the two previous steps as often as necessary to assign security levels to remaining
extensions that should have a security level higher than the default level 0.
• To save the configuration enter * # and listen for prompt “SAVING CONFIGURATION”,
followed by “CONFIGURATION HAS BEEN SAVED”.
3.6.2.5 How to Input PIN Numbers into the ACU-1000 Database
• Enter the “SETUP MODE” by entering * 9 9.
• PIN numbers are entered into a database for the ACU-1000 globally; therefore, it is not
necessary to select a particular extension.
• Enter the “Program PIN” command * 3 0 n n n n x, where n n n n is the four digit pin and x
is the desired security level of the PIN from 0 to 9. Example: If the PIN chosen is 1234
and the associated security level desired is 8, enter the command * 3 0 1234 8 and listen for
the “READY” prompt.
• Repeat the previous step as necessary to input all PIN numbers to be used by the system.