Instruction manual

ACU-1000 Operations Manual
Interoperability Now 2-81
9. After a short delay (10-15 seconds), the following dialog will appear: the DSP will
be reset and restarted with the new software activated.
Figure 2-37 Successful Programming Announcement
10. Click OK to close the AutoUpdate dialog.
11. Verify the new version of the software has been loaded correctly by browsing to the
IP address of the DSP, and validating the Firmware version matches the latest
release (per the website).
Figure 2-38 DSP Module Information Page
12. This completes the process for updating the DSP Module software.
2.15.3 DSP-3 Configuration Programming via Browser
The DSP-3 configuration is the same as for the DSP-2.