Product specifications

88
must be already connected before the PDA can use it. To connect via ActiveSync follow these
steps:
1. On the Pocket PC check Settings > Connections > Connections > Advanced >
Network Card.
2. In the top menu, ensure that the setting is 'Work'.
3. On the PC be sure that the WayPoint
tm
PDA shows “connected” on the ActiveSync
display.
4. In ActiveSync under Tools > Options > Rules ensure the Pass through setting is also
set to 'Work'. The setting in active sync and the PDA must agree.
Map Activation Problems
If the unit does not permit you to install a map set that you own you have a map activation
problem. To fix this problem you need to tap Map Tools and then Repair Activation key.
If you have an Internet connection this will automatically fix the activation key based on the
Mobile Crossing database information. Otherwise you will see the Device ID page as shown at
the left below. You can use the data on this page via phone or the Mobile Crossing web site to
retrieve your Map Activation key. Tap Next to enter the activation key
Flash Disk repair
If you are attempting to load a region on your Flash Disk area and there isn’t room you may need
to erase the current maps that are on the card. Generally this can be done simply by removing the
current region from the area but if there are still maps remaining you can use the Map Tools >
Erase Flash Disk command to clean up the map directory on your Flash Disk. This will
remove the entire contents of your map directory.
Map Loader will not be able to remove maps if you have them open in the WayPoint software.
Be sure that you exit the WayPoint program using Tools > Exit.