Product specifications
13
Getting Started
2. For a WayPoint
tm
200 mount the GPS receiver in the bracket on the back of the unit.
The GPS power cable should be attached between the mount and the GPS.
3. Install the WayPoint PDA in the vehicle mount by sliding it in from the top or pressing it
between the rubber side clamps. Be sure the unit plugs into the power/serial connector
near the bottom of the mount.
4. Plug the audio cord into the headphone jack on the PDA and insert the other end into
the mount.to use the external speaker for clear voice instructions while navigating. A
volume control is located on the left side of the vehicle mount.
5. Attach the gooseneck to the back of the mount. The assembled unit will look similar to
the next figure. (WayPoint 200 shown)
6. Find a suitable place in the car to mount the assembly.
The unit can be mounted to the left or to the right of the driver where it can be easily seen.
The WayPoint 100 needs to be mounted where the GPS will have a clear sky view unless an
external antenna is used. Consideration should be given to possible passenger use.
7. Once the location is chosen, the area should be cleaned so that the suction cup will stick.
8. Attach the suction cup to the windshield and depress the lock on the back to seal the
connection. A tighter seal can sometimes be made with a damp suction cup.
9. Plug the power cable into the unit on the lower right side. Route the power cable down
to the power (cigarette lighter) outlet and the installation is complete.
Alternate Installation of the Bluetooth GPS
WayPoint 200 customers may wish to find a remote location for their Bluetooth GPS near the
base of the windshield to ensure that the unit will have a good sky view for satellite reception.