Product specifications

12
to run and the RAM contents are maintained (see “Maintaining the Batteries” on page 24 for
more information).
Furthermore, if you turn your WayPoint
tm
PDA on again within 4 hours, operation will resume
where you left off the last time you used the device. After 4 hours the unit starts with the Today
screen.
To turn your WayPoint PDA off, press the power button located
on the front of the device
Your WayPoint PDA is set to turn itself off after three minutes of
inactivity when operating on battery power. You can change these
settings by tapping Setting on the start menu, and then selecting
the System tab and tapping Power. The Advanced tab is shown
above.
This setting can be overridden by the WayPoint navigation
software. When a GPS is in use it is usually desirable to leave
power on all the time, even when using batteries. See
“Starting the
GPS” on page 40 for more information.
Turning on your Bluetooth GPS
The Bluetooth GPS needs to be charged for at least an hour prior to its first use. It should be
fully charged before removing power. A full charge will require up to 8 hours or even more if the
unit is on.
Plug the GPS into the AC adapter. The charging light will turn off when the unit is fully charged.
When used in a vehicle, the unit can be plugged into the DC power cable attached to the vehicle
mount to prevent the GPS battery from running down. The unit may be used without the cable
for full wireless operation. The battery life of the Bluetooth GPS is about 8 hours between full
charges.
Vehicle Installation
Safety First!
• Do not mount or install any of the brackets, devices, or cables in front of any air bag.
• Do not mount any object where it obstructs the driver vision.
• Do not route any cable where it interferes with the operation of the vehicle.
Follow these steps to install the unit.
1. If you have a WayPoint 100 place the GPS receiver in the CF slot.