Product specifications

125
1. Remove the battery. and use the stylus to turn off the power and then back on. (Hard
reset)
2. Depress the voice memo button on the side of the unit.
3. While holding the button down, reinsert the battery and back cover.
4. Continue to hold the button down and look at the screen side - The top banner should
show “E-boot” after a short period.
5. Let go of the Voice Memo button.
6. The screen will prompt for the CF card. Insert it now if not already done. Wait for the
upgrade to finish.
7. Repeat step 1.
8. Reinsert the battery and battery cover. After a few seconds the standard WayPoint
tm
PDA start screen should appear.
9. Follow the on screen instructions to set up your WayPoint PDA.
After the firmware is installed you can reload backups or software as needed