Product specifications

102
you will need to re-install your programs, reload backed up files and adjust the settings to suit
your personal preferences.
Master Power Switch
Slide the Master Power Switch from on to off and then back to on again. The figure shows the
back of the stylus being used to change the switch.
Adding Hardware to your WayPoint PDA
The Mobile Crossing
tm
WayPoint
tm
PDA is a very versatile unit. It is possible to add external
devices to the unit to supplement the hardware you received. Extra devices can be plugged into
the serial connector on the bottom of the unit, hooked via the IrDA (Infrared) port, or plugged
into the CompactFlash slot. The following I/O slots are available:
• COM 1: Serial Port. This is available as separate pins on the USB / Power connector on
the bottom of the unit. Baud rates up to 115 Kbps can be supported. The pin-out of the
connector is the same as an iPAQ. This can support modems, cell phones, network
hardware, and even other GPS devices.
• COM 2: reserved
• COM 3: CF Card slot. This slot can support I/O devices and memory devices when the
WayPoint GPS solution is not plugged into the slot. Power is supplied to the device
plugged into this slot. Do not use devices that require more than 500 mA. There are a
wide range of I/O devices that will work in this slot but Mobile Crossing cannot
guarantee that any particular device will work.
• COM 4: IrDA. This is the port used for beaming files between units.