User's Manual

ManualsBrandsMobile Communications ManualsElectronicsDual Band Bi-directional Booster

For use with:

2G, 3G & 4G Cellular Devices

The BST220-15 Dual Band RX/TX 800/1900Mhz

Signal Booster with Smoothtalker proprietary

" Stealthtech Signal Technology "

Increases your Cellular and PCS Band Signals, expands your service

coverage area, enhances voice call quality and significantly increases

Data speeds

The Intelligent CPU monitors the environment in which the amplifier is operating

and continuously adjusts itself to prevent Oscillation and also automatically

prevents any RX/TX overload to both the Cell Phone and Cellular Tower while

giving you maximum signal improvement. It is easy and simple to install and you

can be up and running in minutes

Series: BST220-15

User Manual & Instructions

This is a CONSUMER device

BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your provider's consent.

Most wireless providers consent to the use of signal boosters. Some providers may not consent to the use of this

device on their network. If you are unsure, contact your provider.

You MUST operate this device with approved antennas and cables as specified by the manufacturer.

Antennas MUST be installed at least 20 cm (8 inches) from any person.

You MUST cease operating this device immediately if requested by the FCC or a licensed wireless service provider.

WARNING. E911 locator information may not be provided or may be inaccurate for

calls served by using this device.

Summary of content (4 pages)

PAGE 1
User Manual & Instructions Series: BST220-15 For use with: 2G, 3G & 4G Cellular Devices The BST220-15 Dual Band RX/TX 800/1900Mhz Signal Booster with Smoothtalker proprietary " Stealthtech Signal Technology " Increases your Cellular and PCS Band Signals, expands your service coverage area, enhances voice call quality and significantly increases Data speeds The Intelligent CPU monitors the environment in which the amplifier is operating and continuously adjusts itself to prevent Oscillation and also automat
PAGE 2
Initial Setup Assembly & Installation 1-First make sure that no power is connected to the booster. Connect the inside antenna or cell phone holder, the outside antenna and power supply to the booster. Please make sure to connect each item in to the correct ports as indicated on the booster. 2-Place the antenna on the outside of the vehicle and keep it separated as far as possible from the inside antenna or cell phone holder.
PAGE 3
All parts shown may or may not be included depending on the Smothtalker Booster Kit part number configuration Phone/Device Antenna Connection cable Signal Booster DCH6i: DC 6V Power Supply; Install type DCH6HV: AC/DC Wall 6V Power supply Outside Antenna DCH6Csw: DC 6V Power Cigar Socket type Adapter To comply with FCC rules, this booster must only be operated with cables, antennas and coupling devices that have been approved for use with this equipment For specifications of any of the Smoothalker FCC
PAGE 4
Important: 1-Use only the power supply included with the booster. Connecting any other power supply at any time will result in damage to the booster and will void the warranty. 2-Do not turn on the power switch until ALL cables have been screwed or plugged into the booster or you can cause damage to the booster. 3-It is the user's/operator's responsibility to maintain a minimum distance of 8 inches separation from the antennas to any person. Notes: 1-This booster is not user configurable.