User's Manual

ManualsBrandsMobile Communications ManualsElectronicsDUAL-BAND SINGLE DIRECTION PCS/CDMA AMPLIFIER

User Manual & Instructions

Typical Desktop Installation

PLEASE NOTE: It is normal for the booster to be quite warm while the phone is in use state.

Getting Started:

Parts required

(not all are

included pls

check your

Model#)

Pls note: The co-ax cable connectors on the BRM120 are only available from Smoothtalker.com or

Authorized Smoothtalker Dealers and are MCT type co-ax. Do not attempt to insert any other type

of co-ax connector into the MCT connector or you will damage the unit and void the warranty.

For best performance the BRM120 should be used ONLY WITH GENUINE Smoothtalker

Antennas/co-ax connectors and power supplies

Initial Setup Installation & Assembly:

During this process you will join the inside/outside antenna/Pwr cable to the BRM120 amplifier unit as

follows:

1)Check to be sure that your BRM120 kit includes an external and inside antenna and a 12V Pwr

Supply

2)Power Source:

Please locate your 12V power source and make sure that the cable will be able to reach the final

location of your BRM120 amplifier unit. Do not turn on the power switch until ALL cables have been

screwed or plugged into the BRM120 Unit and Located per below

3)Internal Antenna:

Please determine a suitable location for the interior antenna, one that is preferably within 20 inches

of where you will be using your cell phone/laptop or other mobile device

4)External Antenna:

Please locate this on the vehicle roof (metal) and keep it as far away from the interior antenna as

possible

For home desktop installation please locate the exterior antenna outside of the house for best

performance. If this is not possible please locate the exterior antenna as close as possible to an

exterior window.

After all the above Installation & Assembly process in complete you are ready to turn on the

BRM120 Dual Band Wireless 800/1900mhz amplifier

Operation

1)Green LED: Turn power switch to ON position and Green LED will become Green ON constant.

This indicates that the unit has power and is in an operational state

2)Red & Orange LED's: These must be in the OFF state to indicate that the BRM120 is working in the

"trouble free state". Observe that the Red & Orange LED's are in the OFF state and are not flashing

On/Off or Constant ON state. If they are flashing ON/OFF or Constant ON, then you will need to

separate the interior and exterior antennas until the orange and red LED lights turn steady OFF

3)You are now ready to enjoy Improved Signal Coverage and Enhanced Data Speeds

LED'S: There are 3 LED indicators on the outside of the BRM120 unit as follows:

Green LED Power On/Off Indicator

Red LED 1900MHz Trouble Indicator

Orange LED 800MHz Trouble Indicator

BRM120AA

Amplifier unit

12V Power DCH14

ACX100

12V Install

DCH15

12V Wall power supply

DCH13HV

Inside Antenna

SEMP1

Inside Antenna

SEMR1

Outside Antenna

SEM2MX