User's Manual

Control Panel: Understanding the Control Panel and LED lights
Outside Signal Level/RX Power LED Indicator Light States
General: Mobile networks, phones and data devices operate in two frequency bands
(800Mhz & 1900Mhz). The Stealth Booster will amplify signals in both bands if they are
present. The band that the phone or cellular data device will transmit (TX) and receive (RX)
on is determined by the cellular provider and cannot be chosen by the user. The booster
LED lights will indicate outside signal level and booster gain. The ‘Master Control’ button
on the control panel will allow the user the option to increase gain, decrease gain or shut
off one or both of the frequency bands.
Receive Signal Power Level
(Orange LED)
Master Control
Switch
Gain Level
(Green LED)
Control Buttons for:
Manual Gain - 2dB steps
Receive Signal Power Level LED lights: three orange LED lights for each frequency band
receive signal (RX) power being amplified by the booster and transmitted into the building.
This indicator is affected by two things : the outside signal and attenuation that is applied
by the user or the automatic controls of the booster. The highest level signal being dis-
played by the booster lights can belong to any service provider, not necessarily your service
provider. Note: if attenuation (gain reduction) has been applied by the automatic controls
of the booster or by the user, you may see low signal indication on the booster LED lights
even though the true outside signal is strong.
LED Light Brightness: the user can control the LED brightness of all LED lights by pushing
the up or down arrows on the control panel.
Outside Signal Level LED LED1 LED2 LED3 Flashing RX Power
3 Lights Solid ON No Excellent
Good
Fair
Fair to Low
Low
Very Low
Yes
No
Yes
No
Yes
2 Lights Solid ON,
3rd Light Flashing
2 Lights Solid ON,
3rd Light OFF
1 Light Solid ON,
2nd Light Flashing
1 Light Solid ON,
2nd & 3rd Lights OFF
1 Light Flashing,
2nd & 3rd Lights OFF
Pg. 8 Pg. 7