Installation Guide

Document Name: iRISupply™ Installation and Assembly Guide
Published: 05/11/2004 Doc #: Version 2.0
Rating
120 V, 60 Hz
Warning
Do not exceed
10A total
current per
cabinet
Figure 2 - Powered Auxiliary Safety Label Location
1.2. General Safety Information
The following are generating Warning Messages that
will appear in this Installation and Assembly guide.
These warning messages should be followed at all
times.
WARNING:
Prior to installation and maintenance always unplug
iRISupply™ from the power outlet.
WARNING:
Unplug iRISupply™ from its power source prior to making
any wiring changes.
WARNING:
Do not plug external devices into the iRISupply™ Cabinet
System power strips during service.
Document Name: iRISupply™ Installation and Assembly Guide
Published: 05/11/2004 Doc #: Version 2.0
39
3.3.6. Network Connectivity
To test proper LAN connectivity, complete the following
steps:
1. From a DOS command prompt type in the
command: Ping “ipaddress”. The ‘ipaddress’ will
correspond to the ip location of the cabinet in
question.
2. The system should respond with output similar to
that shown in Figure 44.
Figure 44: Ping Results
3. If the message “Reply from ‘ipaddress’ :….” is
returned 4 times, the computer is properly
configured on the network.
3.3.7. Remote Access Testing
Once the cabinet is properly configured and on the
network, the remote access functions can be tested.
Each installation will vary depending on the remote
access method and specific software used. The
general process will be as follows and will be executed
by somebody located at Mobile Aspects’ offices.
Execute the following steps:
2