Installation Guide

Document Name: iRISupply™ Installation and Assembly Guide
Published: 05/11/2004 Doc #: Version 2.0
Document Name: iRISupply™ Installation and Assembly Guide
Published: 05/11/2004 Doc #: Version 2.0
13
Figure 8 - Lock/Switch Cable to Patch Panel Connection
NOTE
Insert all lock / switch cables into the control
cabinet first before inserting the other cabling
due to the size of the connector.
Figure 27 - Key at 'On' Position
2. Depress the ‘Power’ button. At that time the
computer will boot-up and the IRISupply™ software
should load and start running.
3. When the computer has turned on, turn the power
key vertically (Figure 28). The central Blue LED will
now be illuminated because the computer has been
powered-up. If the Blue LED is not illuminated, you
have not successfully turned on the unit. Repeat
step 2 and hold the ‘Power’ button down for a
longer period of time.
3.1.2. Matching Board Power Connections
Each matching board needs to have power supplied to
it from the control cabinet. The power cables are
plugged into the upper connectors on the patch panel
at the appropriate cabinet location. This connector is
identified as the 6-position white connector (see Figure
9). The connector is keyed so that it will only connect
in one way. The following procedure describes how to
connect the power cables.
Figure 9 - Matching Board Power Connector
28