Installation Guide

Document Name: iRISupply™ Installation and Assembly Guide
Published: 05/11/2004 Doc #: Version 2.0
Document Name: iRISupply™ Installation and Assembly Guide
Published: 05/11/2004 Doc #: Version 2.0
29
NOTE
Do not unplug the lock/switch cable when the
locks are energized.
1. Ensure that the lock/switch cables are appropriately
connected to its corresponding compartment door
(Figure 7).
Figure 28 - Key at 'Standard' Position
4. If the cabinet does not power up, ensure that
everything is plugged into the power strips in the
back of the cabinet and that both power strips have
their ON/OFF switch in the ON position.
Figure 7 - Lock/Switch Cable to Hardware Connection
5. Power up testing is complete when the system
display shows the Mobile Aspects Logo (Figure 29).
2. Route the lock/switch cables from the compartment
to the control cabinet through the wiring trays
provided on the top rear of the cabinets.
3. Route the lock/switch cables into the control
cabinet through the holes at the end of the trough
of the control cabinet. Use the hole nearest the
cabinet being connected
4. Connect the lock/switch cable to the appropriate
connector in the patch panel (Figure 8).
Remember that the cabinets are identified from left
to right as A through E.
Figure 29 - iRISupply™ 'Start-Up' Screen
12