User manual

EN
B40 DC/AC Operation
11
Connecting the cooler to 12 V (thermoelectric mode)
I
NOTE
In thermoelectric mode, the thermostat has no function and the
device cannot deep freeze.
➤ Make sure the cable between the cooler and the battery is protected by a
fuse (maximum 5 A).
➤ Plug the 12-V connection cable (fig. 1 2, page 3) into the cigarette
lighter socket or a 12-V socket in the vehicle.
✓ The cooler starts cooling the interior.
➤ To switch off the cooler:
– Disconnect the plug.
– Wind the cable around the two holders on the back of the device for
storage.
I
NOTE
Disconnect the cooler from the battery when the engine is not
running, as otherwise the battery will run down.
Connecting the cooler to 230 V (compressor mode)
➤ Connect the 230-V connection cable (fig. 1 3, page 3) to the 230-V AC
mains supply.
➤ Open the lid of the thermostat (fig. 2 3, page 3) by pressing down on it.
I
NOTE
Press down on the lid again to close it.
➤ Turn the thermostat (fig. 2 3, page 3) clockwise to the required position.
I
NOTE
The further you turn the thermostat towards “MAX”, the lower the
refrigerating temperature.
✓ The cooler starts cooling the interior.
➤ To switch off the cooler:
– Turn the thermostat (fig. 2 3, page 3) anti-clockwise to “0”.
– Disconnect the plug.
– Wind the cable around the two holders on the back of the device for
storage.