User's Manual

INSTALLATION & SETUP RECEIVER/TRANSMITTER OPERATION
The Mobi® Pure Sounds™ transmier is designed to be powered by either
rechargeable baeries (provided) or the AC/DC adaptors.
Using AC/DC adaptor:
• Plug the connector of the AC adaptor into the DC Jack on the unit (g.
7 pg. 6, g. 12 pg. 7).
• Plug the power cord into an outlet.
• Press the Power On/O Buon (g. 1 pg. 7) to turn ON your receiver.
• The power indicator lights will illuminate indicang units are ON
(g. 5 pg. 6, g. 11 pg. 7)
Using Baeries:
• Remove the belt clip (g.8 pg. 6) by sliding the clip downwards
• Remove the baery door on your receiver (g. 9 pg. 6)
• Plug in the supplied baery pack into your baery compartment
• Return baery cover and belt clip to their original posion
Note: Baery life is between 3-4 hours. When monitoring over long periods
and, in parcular, overnight, it is recommended to use AC adaptors for the
receiver.
Warning:
1. Use on the supplied baery pack with your receiver.
2. Do not mix old and new baeries.
3. Do not mix alkaline, standard or rechargeable baeries
4. Remove the baeries during long periods of non-use.
5. Use only the AC adaptors supplied with the package.
Note: Transmier only funcons with AC Adaptor.
Receiver Power ON/OFF
Press the Power On/O Buon (g. 1 pg. 7) to turn on your receiver. The power
indicator light (g. 5 pg. 6) will turn red indicang receiver is ON.
Volume Adjustment
Press the volume up (g. 2 pg. 6) or volume down (g. 3 pg. 6) to adjust the
volume to the desired level.
LED Indicator Lights
The Link Indicator Light (g. 6 pg 6)
will blink connuously if your
connecon to the receiver is poor or lost.
The Sound Indicator Light (g. 4 pg 6) will blink when sound levels increase
Auto Mute/VOX Acvaon Seng
Your receiver is equiped with automaca mute seng. When sound levels
reach a preset level the mute opon will engage to conserve baery power,
once the transmier picks up noise the receiver will automacally begin trans-
ming.
Note: If link is lost between transmier and receiver you must place both units near each
other, turn them o then on and link will resume.
Transmier Power ON/OFF
Your trasmier will automacally turn ON once you plug in the AC/DC adaptor
(g. 12 pg. 7)
8 9