User manual

Start
Switch on Mobi-Click Compact
The yellow LED comes on
Ready for use
8 9




The green LED begins
to flash and the yellow
LED turns off
Switch on
Press the ON/OFF-button for
about 5 seconds
Automatic GSM network
search (ca. 20 sec.)

A dual tone indicates that
telephone mode has started
Mobi-Click
Compact
works only
if...
 …it is switched on and
the accumulator
is loaded.
 …the PIN-code of the
SIM-card has been
changed.
 …the SIM-card is put in
correctly.
 …a perfect GSM
reception is given.
Mobi-Click
Compact
works only
if...
 …it is switched on and
the accumulator
is loaded.
 …the PIN-code of the
SIM-card has been
changed.
 …the SIM-card is put in
correctly.
 …a perfect GSM
reception is given.
Press until you hear "peep".
(During this time the red LED
flashes)
Mobi-Click Compact was produced by keeping to the strict
manufacturing and quality controls. Thus your device works correctly
and to prevent that the guarantee expires there has to be considered
the following security councils:
 1 Mobi-Click Compact
 1 SIM-card
 1 mobile phone for changing the PIN-code of the SIM-card and
to program the three phone numbers
You need
Connect Mobi-Click
 Ensure the Mobi-Click is turned OFF and connect the battery charger
to ensure that the battery is fully charged.You will hear a short peep
tone when the charging cycle begins
 Orange LED is blinking: the battery is not charged
 Switch on your device as described on the left page. You should
NOT turn on the Mobi-Click with the charger connected. An
integrated protection circuit is built into the Mobi-Click to ensure
that the battery delivers optimal supply to the Mobi-Click.
What to do if...
…there is no dual tone and the green LED does not light?
 Is the device switched on?
 Does the battery have enough power?
 Is the PIN-code changed, and is the SIM-card inserted correctly?
 Attention! General Reset (s. pages 35)
Security advise
 Take care of your Mobi-Click Compact.
 Mobi-Click is full of electronics and sensitive sensors. Therefore
do not drop Mobi-Click, do not expose Mobi-Click any hard hit as
the electronic printed circuit board could get any defect because
of this.
 Moisture, heat or cold could influence the perfect work of the
device strongly and lead to damages.
 Do not try to open the Mobi-Click device. Thus you damage the
housing and you loose the guarantee service.
ATTENTION!
Should the green LED not start flashing, turn off the Mobi-Click using the ON/OFF-button and
check to ensure the SIM-card has been inserted correctly. Also ensure that you are in a good
mobile phone reception area.
For switching off the device,
also press the power ON/OFF
key (the yellow and the green LED
will flash during this operation).