User manual

Important information
1. First steps before using the Mobi-Click Compact
Mobi-Click Compact possesses an integrated circuit for the protection of the battery from over and under
charging as well as from short-circuit. This protective circuit is activated with a small slide switch (see design).
In order to avoid damage during transport, this slide switch is set to the OFF position at the factory. Before
first use the protective circuit must be activated by moving the slide switch from the OFF to the ON position.
(View of the Compact from the rear)
To set the Compact in operation
.Open the rear cover
.Open the SIM-card caddy
.Using a pointed tool, move the slide switch to the ON position
.Insert SIM-card
.Close the SIM-card caddy
.Close the rear cover
.Connect the battery charger
.A peep signals indicates that the Compact has successfully started
Important information
.
1. Leave the Compact connected to the battery charger for a minimum of 40 Minutes to ensure that the battery is fully
charged.
2. 2. Before switching on the Compact (with the ON/OFF key) the battery charger must be
disconnected. Once Compact is switched on, the battery charger can be connected or disconnected as
required, or be permanently connected. This way, a temporally unlimited working time of
Compact can be guaranteed (e.g. monitoring during a vacation).
3. 3. Compact allows the user a variety of programming options and adjustments of the device
functions to suit individual requirements of the user. If during the programming something does not
really work, you can reprogram the device, reset the Compact by moving the reset switch (located
under the rear cover) to the OFF position for a minimum of 5 seconds and then ON again. This
does not erase previous settings, but sets the Compact ready to receive new instructions.
Restart the Compact after resetting.
54