User manual

Alarm display
Because the contact itself does not own a sole-alarm-display, an identification is given as follows: if the alarm report is given by
SMS or e-mail, then a release of the contact can be determined because even though there was an alarm reported, the sensors
had no sole release.
Sole Monitoring
With the command SET ALARM Mobi-Click will not only put into the "security-mode". When a contact is connected it will be
focused automatically. Because all the other sensors will not be activated with this command, solely this contact will be monitored.
Monitoring together with other sensors
When one of the sensors is switched on, then this contact will be monitored automatically as well
(e.g. SET HOME, SET VIBRA etc.).
Function/Software
The interface of Compact is normally served for the data-communication to and from external system-components. The logical
standby level is in this case LOW. If there is a connection, then this stand-by level will logically be pulled up to HIGH. Therewith
Mobi-Click Compact recognises with the next set function (SET XXX) or with the next mode shift (SET ALARM) a standby power
connection and it will begin to monitoring this additional sensor automatically. It is also important to make the connection before
activating the Mobi-Click device via SMS or buttons.
38 39
Set Zone / Area
Security zone and localization of persons or objects
With Mobi-Click you can define protection zones, e.g. your child’s way to school. If the child leaves this area (e.g.
because it enters a stranger's car) you will be warned immediately per SMS and you can monitor the situation if
necessary.
Set Zone
Set Area
Switch on locating monitoring
Set Auto
Switch on vehicle monitoring with locating monitoring.
On the way with the car:
It is possible that not all GSM cells can be detected immediately during the security zones learning process
(especially when driving the children's path to school). Some cells may be working to capacity and therefore
they can not be registered by Mobi-Click. That is why it is advisable for urban areas to cross a security zone
slowly or more than once if possible, this allows for every possible GSM cell to be registered by Mobi-Click.
(Security zones can be tested with "Test Area".)
Activate locating
Define security zone
Set Alarm
How can I connect extern devices?
Learning mode is activated. Mobi-Click gives a short peep every 20 seconds. When finding a new unknown GSM
zone the dual tone signal is heard. Interrupt learning mode: when Mobi-Click is switched off previously learnt
zones remain saved. Reactivate learning mode: "set zone". Mobi-Click can store a maximum of 48 zones. When
this number is exceeded there will be an error tone (peep) and the LED lights continuously. Zones will remain
saved. Stop learning mode: Switch off Mobi-Click. "Reset zone": Security zones will be deleted.
Mobi-Click can be connected to an external contact. This contact generates an alarm report to the programmed target call number
in the programmed communication forms (SMS, call, e-mail).
Important: Switch your Mobi-Click Compact only on/off when the contact is not connected yet. Else, it can be possible that the
connected hardware will not be interpreted rightly and/or the switching on/off function will not function in proper form.