User guide

Lockable Tablet Stand

Setup Sheet

Tools Required

• Pencil (to mark hole placement)

• 3/16"

drill bit (for cash drawer surface drilling)

• Phillips head screw driver and power drill will be required to mount stand to desired surface

No tools required if used as a stand-alone solution

If stand will be bolted to a at surface:

Hardware is only provided for top of cash drawer integration.

Hardware is NOT included for any other mounting surfaces – screws need to suit speciﬁc desktop or platform thickness.

Components Provided

Cash Drawer Top Surface

Mount Hardware Kit

Qty.: (3) #8 screws

(3) #8 nuts

PAGE 1
Lockable Tablet Stand Setup Sheet Components Provided Cash Drawer Top Surface Mount Hardware Kit Qty.: (3) #8 screws (3) #8 nuts Tools Required No tools required if used as a stand-alone solution If stand will be bolted to a flat surface: • Pencil (to mark hole placement) • 3/16" drill bit (for cash drawer surface drilling) • Phillips head screw driver and power drill will be required to mount stand to desired surface Hardware is only provided for top of cash drawer integration.
PAGE 2
Assembly Instructions STEP 1 (Skip to STEP 2 if using as a stand-alone solution) Firmly secure the base stand to a flat surface with appropriate fasteners. Lockable Table Stand (Holding tablet) a. Three (3) #8 screws and three (3) #8 nuts are provided for mounting stand on top surface of a cash drawer. b. Remove the cash till and inner drawer from cash drawer housing. c. Place stand on top of drawer and mark hole positions with pencil. d. Drill holes on top of cash drawer. e.