Service manual

2. Overhauling
2-7
2.3.2 Measuring center deviation and surface deviation
Measure them with a dial gauge pressed to the flywheel.
(1) Measuring the center deviation, turn the rotor with the dial gauge pressed to the circumference
of the coupling flange. If the biggest value measured on the same circumference exceeds 0.008in.
(0.2mm), it is necessary to repair it.
(2) Measuring the side run-out, turn the rotor with the dial gauge pressed vertically to the coupling
flange. If the biggest value measured on the same diameter exceeds 0.008in.(0.2mm), it is
necessary to repair it.
SG06059
A
: Flywheel side run-out
B : Housing center deviation