TAS1505 Register your product and get support at www.philips.
Contents 1 Important Safety 2 2 2 Your wireless speaker Introduction What's in the box Overview of the speaker 3 3 3 3 3 Get started Charge the built-in battery 4 4 4 4 Play from Bluetooth devices Play from Bluetooth devices Control playback 5 5 5 5 Product information 6 6 Troubleshooting General Bluetooth 7 7 7 7 Notice Compliance Care of the environment FCC Statement Trademark notice 8 8 8 8 9 EN 1
1 Important • • Safety Important safety instructions • Make sure that the power supply voltage corresponds to the voltage on the back or the underside of the unit. • The speaker shall not be exposed to dripping or splashing. • Do not place any source of danger on the speaker (e.g. liquid filled objects, lit candles). • Make sure that there is enough free space around the speaker for ventilation.
2 Your portable speaker Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. LED indicator Indicate battery or Bluetooth connection status. • Turn the speaker on or off. DC IN • Charge the built-in battery.
3 Get started Always follow the instructions in this chapter in sequence. Charge the built-in battery The speaker is powered by a built-in rechargeable battery. Note · · · · Before use, fully charge the built-in battery. The USB Type C socket is for charging only. It takes you approximately two hours to fully charge the battery. Rechargeable battery has a limited number of charge cycles. Battery life and number of charge cycles vary by use and settings.
4 Play from Bluetooth devices 3 If you cannot find [Philips S1505] on your device, hold down the Power button for 2 seconds to power off before rebooting, and long press it for 2 seconds to enter into pairing mode. With this speaker, you can listen to audio from Bluetooth-enabled devices. Note The speaker can memorize a maximum of eight paired devices. The ninth paired device will replace the first one. Any obstacle between this speaker and a Bluetooth device can reduce the operational range.
5 3.7 V,480 mAh 64 x 64 x 78mm Operation Ambient IP protection class 2.5W RMS 150Hz-18kHz 1.5" 80 Bluetooth Profile V5.0 A2DP V1.3, AVRCP V1.6 20 6 EN 0.14 0 ~40 IPX7* *The IPX7 rating means the speaker driver can be submerged for up to 30 minutes at a depth of up to 1 m.
Philips S1505 If you cannot find [Philips S1505] on your device, hold the for 2 seconds to power off, and then long press the button for 6 seconds to clear the pairing information / enter pairing mode.
MMD Hong Kong Holding Limited may void theuser's authority to operate the equipment. Hereby, TP Vision Europe B.V. declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. You can find the Declaration of Conformity on www.philips.com/support. Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion.
FCC information NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Specifications are subject to change without notice. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license. This product has been manufactured by and is sold under the responsibility of MMD Hong Kong Holding Limited or one of its affiliates, and MMD Hong Kong Holding Limited is the warrantor in relation to this product. TAS1505_00_UM_V1.
