Clock Radio 7000 Series R7606 User manual Register your product and get support at： www.philips.
Contents 1 Important Safety FCC information 2 Your clock radio Introduction What's in the box Overview of the clock radio 3 Get started Install batteries Connect power Set time Turn on 4 Listen to FM radio Tune to FM radio stations Store FM radio stations automatically Store FM radio stations manually Select a preset radio station Show RDS information 5 Bluetooth Play from Bluetooth enabled devices 6 Other features Set alarm time Set sleep timer Adjust volume Adjust display brightness Wirelessly charg
1 Important Safety FCC information • • • • NOTE: This equipment has been tested and • • • Read these instructions. Heed all warnings. Follow all instructions. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG,Inc. and any use of such marks by MMD Hong Kong Holding Limited is under license. Other trademarks and trade names are those of their respective owners. IC-Canada : CAN ICES-3(B)/NMB-3(B) This device contains licence-exempt transmitter(s)/ receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: 1.
2 Your clock radio Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/support. Overview of the clock radio SLEEP 1 • Set the sleep timer. Introduction 2 With this clock radio, you can • • • • listen to FM radio; play audio from Bluetooth-enabled devices; set two alarms to ring at different times; charge your mobile device with the wireless phone charger or USB.
3 Get started Always follow the instructions in this chapter in sequence. Connect the power adaptor to the wall outlet. Install batteries The batteries can only back up clock and alarm settings. Caution • Risk of explosion! Keep the batteries away from heat, sunshine or fire. Never discard batteries in fire. • Batteries contain chemical substances, so they should be disposed of properly. • Do not mix battery types: e.g. alkaline with carbon zinc. Only use batteries of the same type for the set.
4 Listen to FM radio Note • Keep the clock radio away from other electronic devices to avoid radio interference. • For better reception, fully extend and adjust the position of the FM antenna. Store FM radio stations manually 1 In FM tuner mode，tune to an FM radio station. 2 Press and hold PRESET for more than 2 seconds to activate programming mode. The preset number begins to blink. Tune to FM radio stations 3 Press 1 Press 4 Press PRESET again to confirm. to turn on the clock radio.
5 Bluetooth 6 Note Set alarm time • The effective operation range between this unit and your Bluetooth enabled device is approximately 10 meters (33 feet). • Any obstacle between this unit and your Bluetooth enabled device can reduce the operational range. Other features Set alarm Note • • You can only set the alarm in standby mode. Make sure that you have set the clock correctly.
Set sleep timer Charge through USB port This clock radio can switch to standby mode automatically after a preset period. Charge an external USB device through the USB port on the back of this unit. • Press SLEEP repeatedly to select a period (in minutes). The clock radio switches to standby mode automatically after the preset period. To deactivate the sleep timer: • Press SLEEP repeatedly until [OFF] (off) appears. Adjust volume While listening, press -VOL+ to adjust volume.
7 Product information Note • Product information is subject to change without prior notice. Amplifier Rated output power 2W x 2 RMS Operation power consumption <17.1 W Standby power consumption <1 W Dimensions (W x H x D) 153 x 68 x 153 mm Weight (main unit) 621 g Tuner (FM) Tuning range 87.50-108.00Mhz Tuning grid 100 KHz Sensitivity - Mono, 26 dB S/N ratio <22 dBf Total harmonic distortion <3% Signal to noise ratio >50 dBA Bluetooth Bluetooth version Bluetooth frequency V5.0 2.
8 Troubleshooting Warning • Never remove the casing of the product. To keep the warranty valid, never try to repair the device yourself. If you encounter problems when using this device, check the following points before requesting service. If the problem remains unsolved, go to the Philips webpage www.philips.com/support. When you contact Philips, make sure that the device is nearby and the model number and serial number are available.
2021 © MMD Hong Kong Holding Limited. All rights reserved. Specifications are subject to change without notice. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license. This product has been manufactured by and is sold under the responsibility of MMD Hong Kong Holding Limited or one of its affiliates, and MMD Hong Kong Holding Limited is the warrantor in relation to this product. TAR7606_37_UM_V1.
