Specifications

Page 6Rev 0.1 © MMB Networks 2019 RapidConnect Bridge Overview
Copyright © 2019 MMB Research Inc. All rights reserved.
The information in this document is subject to change without notice.
This document is believed to be accurate and reliable, but the statements
contained herein are presented without expressed or implied warranty.
MMB Networks is a division of MMB Research Inc.
MMB Networks is a division of MMB Research Inc
RapidSE, RapidHA, and RapidConnect are trademarks of MMB Research Inc.
All other trademarks are the property of their respective holders.
July 2019
400 -25 Adelaide Street East,
Toronto, Ontario,
Canada, M5C 3A1
416.636.3145
[e-mail]
www.mmbnetworks.com
PRELIMINARY & CONFIDENTIAL
4.2.3 Labeling Requirements
The host device shall be properly labelled to identify the modules within the host device. The ISED certification label of a module shall
be clearly visible at all times when installed in the host device, otherwise the host device must be labelled to display the ISED
certification number of the module, preceded by the words “Contains transmitter module”, or the word “Contains”, or similar wording
expressing the same meaning, as follows:
Contains transmitter module IC: 8365A-BRD10
Contient le émetteur radio IC: 8365A-BRD10
Or
Contains IC: 8365A-BRD10
Contient IC: 8365A-BRD10
4.2.4 Additional Notice
This module is intended for an OEM integrator. The OEM integrator is responsible for the compliance to all the rules that apply to the
product into which this certified RF module is integrated. Additional testing and certification may be necessary when multiple modules
are used.
A 20cm minimum distance has to be able to be maintained between the antenna and the users for the host this module is integrated
into. Under such configuration, the FCC radiation exposure limits set forth for a population/ uncontrolled environment can be satisfied.
Further RF exposure shall be re-evaluated to the scenario of portable, and collocated use.
4.3 RoHS Compliance
The BRD10 devices do not contain any substances in excess of the maximum concentration allowed by Directive 2002/95/EC. The
module is RoHS compliant.
4.4 FCC & IC Compliance
In the event that conditions as described in the manual cannot be met, then the FCC and ISED authorizations are no longer considered
valid and the FCC ID and IC certification number cannot be used on the final product. In these circumstances, the integrator will be
responsible for re-evaluating the end product (including the transmitter) and obtaining a separate FCC and ISED authorization.