Installation MOUNTING OPTIONS ‘WARNING: To reduces the risk of fire, electric shock, or personal injury, mount the fan to an outlet box marked acceptable for fan support using the screws provided with the AN outlet box. An outlet box commonly sad for the support of lighting fixtures may not be acceptable for fan support and may need to ba replaced. If in doubt, consult a qualified NOTE: You mey need a longer down rod to maintain proper blade clearance when installing on a steep, sloped ceiling.
Assembly 1.Install the suspension system components 1. Insert the ballgown (D) through the canopy(B) and canopy bottom cover (C), and then slide the decorative motor B) are on top. 5 | Bl bel TE wll STEP— —> STEP— —> STEP— —> 2.Assembling the fan WARNING: Failure to properly install the locking pin could result In the fan becoming loose and possibly falling. 1.Route the wires exiting the top of the fan motor assembly (F)through the down rod as shown.
Assembly— Hanging the Fan 3.Description of mounting bracket 1. Lossen the two outlet box screws in the WARNING: To reduce the risk of fire,electric shock or other outlet box. personal injury, mount the fan only to an outlet box or 2.Pass the 120-Volt supply wires through Supporting system marked acceptable for fan support and use the mounting screws provided with the outlet box. the center hole in the mounting bracket (A) 3.
Assembly— Hanging the Fan (continued) 4. Install the light bulb 1.Install the four E12 bulbs by screwing them into the light WARNING:The E12 The light bulb bulb sockets. MAX 25W Type B bulbous. 5. Hanging the fan to the mounting bracket WARNING: to reduce the risk of electric shock, please operate after staring to disconnect the power supply of circuit breaker or fuse box. 1.
Assembly— Hanging the Fan (continued) 6. Making the electrical connections WARNING: To avoid possible electrical Shock tum WARNING: Check fo sea that all connections ars tight, /AN\ the electricity off at the man fuse box before wiring. /N\ Including ground, and that no bare wire Is visible at the I you feel you do not have enough electrical wiring 0 . knowledge or i contact a licensed electrician. connect Terminal blocks, except for the ground wire.
Assembly— Hanging the Fan (continued) 7. How to install the canopy ring cover 1.Align the top cover (B)with the hole knob of the mounting bracket (A)and tighten with screws.
