Instruction manual

--------------------------------------------------------------------------------------------------------------------
This manual may not be copied or reproduced in any way without the express written consent of
MLCS Woodworking.
Copyright 2012. MLCS Woodworking. Page 2
TABLE OF CONTENTS
SECTION 1: Technical Data………………………….…..2
SECTION 2: General Instructions…………………….….3-5
SECTION 3: Unpacking & Checking Contents..………..6
SECTION 4: Assembly, Adjustments & Operations…....7-16
SECTION 5: Maintenance..…………………………….…17
SECTION 6: Exploded Diagram & Parts List………….…18-21
TECHNICAL DATA
Item number/name……………………………..9059/Marvel 42
Motor………………………………120 Volts, 60 HZ, 5.5 Amps
Rated power..……………………………………………..…1 hp
No load speed………………………… 20,000 or 30,000 RPM
Bit shank diameter…………………………………..1/8” or 1/4”
NOTE: If using an extension cord while operating this tool, observe the minimum gauge
requirement as shown in the chart below. Use only UL listed extension cord.
Gauge Total Extension Cord Length in Feet
16 25 feet
14 25, 50 feet
12 25, 50, 100 feet