Instruction manual

--------------------------------------------------------------------------------------------------------------------

This manual may not be copied or reproduced in any way without the express written consent of

MLCS Woodworking.

MAINTENANCE

WARNING! Unplug the tool before changing accessories or bits and making adjustments.

1. Do not clean the tool by using highly volatile liquids such as solvent, gasoline or petroleum

product, etc, because the chemical substances contained in these liquids may damage the plastic.

2. Always keep the tool handle free from oil or grease.

3. Always re-tighten collet and all adjustments before starting the tool after a bit or accessory

has been changed. Loose bits and adjustments can cause unexpected shifting of the tool,

resulting in loss of control and injury from the bit or tool being thrown.

4. CAUTION! To avoid shock or fire, replace power cord immediately if it is worn or damaged

in any way.

5. When the carbon brushes have been worn to their limitation, they should be replaced. Both

carbon brushes should be replaced at the same time.

6. WARNING! Use only accessories recommended by MLCS to avoid injury to the operator

or damage to the tool.