Instruction manual

--------------------------------------------------------------------------------------------------------------------

This manual may not be copied or reproduced in any way without the express written consent of

MLCS Woodworking.

CAUTION! Do not attempt to make bevel cuts with the accessory guide template base

installed on the plunging/tilting base as the bit can come into contact with the template

guide bushing opening and you will ruin the accessory baseplate.

Setting Router Base Bevel:

Bevel cutting with the bit can be done with the router base tilted to the desired angle. Loosen

both bevel adjusting knobs by turning them counter clockwise. Tilt router base to the desired

angle. Re-tighten both bevel-adjusting knobs. Check the bevel angle to ensure it is at correct

angle. Check the router depth of cut to ensure it is accurate.

Note: Depth of cut will usually have to be increased after tilting the router base for bevel

cutting.