Instruction manual

Note: Cross lines for locating and drilling holes are accurate. The illustration of subbase may vary

slightly in size and design, but is accurate enough for cutting the rubber gasket if required.

Page 12

Refer to pages 4-5-6 before using template

Additional Templates Available on Website

Drill .500" hole

through router

table insert plate

install #30 dust cover insert

into .500" hole and press flush

with top of insert plate

Router Raizer Access Point

NOTE: This hole must be drilled 1/2" or .500"

for #30 dust cover insert to fit properly.

Sub-base mounting holes

Use this 6" scale to check accuracy when copied

MLCS Marvel 62

Router Raizer Access Point

5/16" reference circle for drilling

subbase.

.500" reference circle

for drilling table top or

insert plate.

1/2" = .500

Router table fence reference line