Instruction manual
Power
Cord
Fold
Down
Fold
Down
Power
Cord
Fold
Down
Fold
Down
#21 lead screw
#19 short drive nut or
#20 long drive nut
# 21 Lead Screw Update
#21 lead screw, #19 short drive nut, #20 long drive nut are hardened parts. You may experience resistance
when threading #21 lead screw into #19 short drive nut, or #20 long drive nut. This resistance is only the
first 1/4" of the # 21 lead screw and once threaded in will not affect the Router Raizers performance. If you
encounter this problem follow instructions below.
Caution: As these parts are hardened Do Not Attempt To Retap These Threads With A Tap Or Die
11/16" wrench
Place red grease onto threads of #21 lead screw. Place a 11/16" wrench on the #19 or
#20 drive nut. Insert # 29 speed wrench into top of #21 lead screw. Use the speed
wrench to thread #21 lead screw into drive nut until resistance is no longer felt.
Any further problems please call for assistance
1-866-266-1293
Page 18
Access Hole Locating Pin
Plunge
Post
fig 1
#1 Mainshaft
#1 Mainshaft
Head
Bottom
Router Base
After installing the Router Raizer use this pin to simplify locating the Router Raizer access hole required
through the original subbase or router table.
Using fig 1 support router upside down on bench and place locating pin into bottom of #1 mainshaft head.
Secure subbase to router base gently tightening screws. Using a hammer gently tap the subbase over the pin.
Remove subbase and drill hole on center punch mark using the Router Raizer template instructions.
Locating Hole in Original Subbase
Locating Hole in Router Table
If your router table is already drilled to mount the router,
use above step using table or insert plate in place of
original subbase.
If your router table or insert plate have not been drilled
use the provided paper template or original subbase
to first locate and drill the router mounting holes.
NOTE. Read Router Raizer template instructions before using locating pin
Duplicate tempates for Bosch 1619 EVS
© 2002 Router Technologies
METRIC EQUIVILANTS FOR INTERNATIONAL CUSTOMERS
Note: The following metric drill bit or wrench sizes may be substituted
for all operations other than drilling hole for #30 Dust Cover Insert.
1/8” = 0.125" 3.20mm = 0.126"
3/32" = 0.093 2.4mm = 0.094
5/32" = 0.156" no metric equivilant, this hole must be drilled to 5/32"
7/32" = 0.218" 5.5mm = 0.216"
5/16" = 0.312" 8.0mm = 0.315
21/64" = 0.328" 8.3mm = 0.326" or 8.5mm = 0.334"
1/2" = 0.500" 12.8mm = 0.503 or 13mm = 0.511
11/16"= 0.687" 17.5mm = 0.689" or 18mm = 0.708"
3/4" = 0.750" 19.0mm = 0.748
# 30 Dust Cover Insert must be 0.500" use a 12.5mm bit
and sand hole to fit cover. 12.5mm = 0.492"
Locating Pin
Original Subbase or Router Table
#29 Speed
Wrench