User manual

PASS-FAIL MODE
59
5959
59
Multi-step
configuration
Overview ......................................................................70
Configure beep setting ................................................72
Configure the Average .................................................73
Enter multi-step mode.................................................74
Create new program ....................................................74
Edit program step ........................................................76
Copy (duplicate) program step ...................................79
Delete program step....................................................79
Multi-step run Run program ...................................................... 80
Multi-step file
operation
Save program ..................................................... 83
Recall (load) existing program............................ 85
Delete existing program ..................................... 86
LCR-8000G Series User Manual
60
6060
60
Single-Step Test Configuration
Overview
Background / test
type
Pass/Fail test checks whether the measurement
result sits between the Hi(high) and Lo(low) limit.
Three methods are available: absolute limit,
percentage and delta limit.
Absolute
limit
The Hi and Lo limit are defined by
absolute values.
Percentage
limit
The Hi and Lo limit are defined by the
distance (percentage) from the
Nominal value.
Nominal
– ##%
Pass
Nominal
Nominal
+ ##%
Delta limit
The Hi and Lo limit are defined by the
difference from the nominal value.
C S
Series capacitance
X
Reactance
Test item
C P
Parallel
capacitance
B
Susceptance
L S
Series inductance
Z
Impedance
L P
Parallel inductance
Y
Admittance
R S
Series resistance
R DC
DC Resistance